Download Spectra T50e Library - Assisted Self
Transcript
Chapter 4 – Replacing or Cleaning a Tape Drive a. Disconnect the interface cable (SCSI or FC) and the terminator, if one is installed (Figure 4-6, step a). b. Unscrew the screws, grasp the handle, and pull the tape drive straight toward you while you support it with both hands (Figure 4-6, step b). d Tape drive cover plate d Screws b Screws (two each side) Terminator a SCSI Cable Finger screw Notes: Full-height tape drives have four finger screws. Half-height tape drives have two finger screws. See Figure 4-5. The cover plates have two screws each. Figure 4-6 Rear panel – Remove tape drive c. Press OK to continue or Cancel to cancel the action. d. Install the tape drive cover plate using a #2 Phillips screwdriver and the screws that you removed earlier (Figure 4-6, step f). Note: Each drive bay must be covered for safety and temperature control. Do not leave any tape drive bays uncovered. 5. Package the tape drive in its original packaging, including the antistatic bag. 56