Download Using the Audio Processor Workbench (APWorkbench)

Transcript
UM1545
Getting started
Figure 3.
Startup settings, interface selection
The lower part of the Startup settings dialog, instead, allows specifying the interface to be
used (Figure 3, highlighted in red). Please note that when selecting the AP Interface (use
this option for the LPT interface too) or the USB option, respectively the available parallel
ports or the available COM ports will be enumerated in the drop-down menu on the right.
Select the correct interface and communication port, then press OK. Among the physical
interfaces the Simulation option is also available. Use this option if you do not want to be
connected to an interface (APW evaluation and testing only).
Doc ID 023225 Rev 1
9/64