Download Reference Manual

Transcript
Chapter 2 – FastNEST Overview
18
the opposite of what it currently is. This will mean that a
part that is cut with left kerf will be cut in the opposite
direction with right kerf. This method of cutting is usually
correct for Oxy fuel cutting but could cause a problem with
thick plate plasm cutting where the bevel of the cut is
usually on the scrap when cut with left kerf. If the part is
flipped the part will be bevelled.
Use Search Step If selected the Part Data “Search Step”
settings will be used. The value of “ALL” in the permitted
rotation will be altered from 30 degrees to what has been
set as the Angle Step in the FastNEST Parameters dialog
box. The part will also be nested with the specified search
step. Using search step with fine settings will slow the
nesting process.
Disable Array If checked and calculate arrays has been
selected in the FastNEST Nest Parameters then the part will
not be nested with arrays, each part will be loaded onto the
plate as an individual part.
Entity Reduction When checked nesting will be faster and
interaction smoother for large parts. Entity reduction
reduces the number of entities the program analyses
without reducing accuracy of the nest. It is quite effective
on parts with more than 500 entities.
Initial Rotation This option sets the initial rotation of a
part. By entering the desired rotation then pressing apply
the part will be rotated accordingly.
Indicate Base This function allows the selection of an
entity to be set as the base of a part. The entity selected will
be aligned with the horizontal at the base of the part. To use
this function Indicate Base is selected then the user left