Download TYPHOON - Electrostatica

Transcript
9. Faults
Warning:
 Disconnect the power supply before carrying out work on the unit.
9.1. Air knife fault
Problem
No air from air knife.
Air knife has insufficient
blowing power.
Cause
Blower does not run
Air slot is fouled.
Air filter on blower is
fouled.
Blower operating in wrong
direction
Solution
See blower instructions.
Remove contamination
(see Maintenance).
Clean or replace the filter.
Change direction of
rotation of blower.
Table 1 air knife faults
9.2. EP-Sh-N anti-static bar fault
Problem
No or poor ionisation.
No high voltage on emitter
points
Cause
No high voltage.
Anti-static bar is fouled.
Emitter points are
damaged.
High voltage power unit is
defective.
Short circuit in the HV
cable or anti-static bar.
Solution
Restore high voltage.
Clean anti-static bar.
Return air knife for repair.
Repair high voltage power
unit.
Eliminate short circuit or
return the bar for repair.
Table 2 EP-Sh-N bar faults
9.3. P-Sh-N-Ex anti-static bar fault
Problem
No or poor ionisation.
No high voltage on emitter
points.
Cause
No high voltage.
Anti-static bar is fouled.
Emitter points are
damaged.
No mains voltage.
External fuse is defective.
Transformer is defective.
Solution
See P-Sh-N-Ex anti-static
bar manual
Clean anti-static bar.
Return air knife for repair.
Restore mains voltage.
Replace the fuse.
Replace the bar.
Table 3 P-Sh-N-Ex bar faults
Typhoon_UM_9752902012_GB_V2_1
11