Download Integrator`s Guide

Transcript
Chapter 1: Introduction
Integrating the H200
Successful integration of the H200 within a system requires electronics expertise that
includes:
•
Power supply design
•
Serial port level translation
•
Reasonable radio frequency competency
•
An understanding of electromagnetic compatibility
•
Circuit design and layout
The H200 GNSS engine is a low-level module intended for custom integration with the
following general integration requirements:
•
Regulated power supply input (3.3 VDC  5%) and 1.7 mA continuous current
•
Low-level serial port (3.3 V CMOS) and USB port communications
•
Radio frequency (RF) input to the engine from a GNSS antenna is required to
be actively amplified (10 to 40 dB gain)
•
GNSS antenna is powered with a separate regulated voltage source up to
15 VDC maximum
•
Antenna input impedance is 50 
•
Antenna voltage input is 15 VDC maximum
•
Antenna gain input range is 10 to 40 dB
Features of the H200
Some notable features of the H200 are:
•
Multi-channel GNSS engine (12 L1CA GPS, 12 L1P GPS, 12 L1 GLONASS,
and 3 channels dedicated to SBAS tracking)
•
Sub-meter horizontal accuracy 95%
•
Raw measurement output (via documented binary messages)
•
Position and heading update rates of 20 Hz maximum
•
Quick times to first fix
•
Three full-duplex serial ports, a dedicated RTCM input port, and two USB
ports (one USB host, one USB device)
•
1 PPS timing output
•
Event marker input
•
L-band capable (Hemisphere GPS LX-2™ board required)
•
Fast RTK acquisition and reacquisition times
•
10 cm RTK-enabled heave accuracy
•
Improved heading accuracy with different baseline lengths (up to 5 m)
•
Same form factor as Hemisphere GPS' Crescent® Vector II OEM board
Note: See Appendix B, “Technical Specifications” for complete H200 specifications.
Vector H200 Integrator Guide
3
PN 875-0340-0 Rev A1