Download ISO-SWS
Transcript
ISO-SWS VILSPA/SRON/MPE/KUL Document: Date: Version: osia-master January 23, 2004 4.0 HowTo perform dark subtraction with DARK INTER Page 59 Figure 5: The DARK INTER main window for an SWS02 observation after setup. The middle plot of the left panel shows again the flux of the selected detector plotted against SPD index, but now zoomedin to dark level and using different plot symbols. The y-range of this plot is defined such that all dark values, measured by the current detector during the whole observation, are displayed. The individual dark points are plotted as crosses, any other data points as dots. The x-scale and the color coding is the same as in the upper plot. The third, lowest plot on the left panel and the whole right panel are filled at a later stage of using DARK INTER. The text window between detector and scan/phot selection shows corresponding information from the scan table, like the number of scans, photometric checks and darks for the current detector/band (and after a scan or phot has been selected also information on individual scans/phots). The second text window is reserved for error messages. More details on the scan/phot selection and the various buttons in the lower part of the control board are given in the following sections. To familiarise users to the dark inter processing steps a general recipe, how to use DARK INTER, follows: • A: select the first detector of a band (1, 13, 25, 37, 49 or 51) • B: use the ’plot’ window to adjust plot scales (if necessary) • C: ’revise dark’ measurements of all detectors of the current band: – C1: select method: ’clipping (mean)’ with ’clip repeat’, ’kappa: 3’ and ’glitches’ (ignored) – C2: [apply it to all darks of current band] • D: perform dark subtraction for all scans and photometric checks of current band: