Download INFO - Chausson
Transcript
CHAP. II Preparation before leaving n PREPARING THE LIVING COMPARTMENT (outside) (continued) The clean water tank is filled through an external orifice marked by a specially identifiable pictogram to distinguish it from the fuel tank on your basic vehicle. Any covers or plugs on air intakes or orifices on all household appliances should be removed. Blanking pieces for the refrigerator grills are supplied as an option by your sales outlet. The WC cassette also needs to be put into service by adding a dose of the appropriate chemical without forgetting to add little water. This operation is done through the outside door (access flap), but can also be done very easily from inside the living compartment. n PREPARING THE LIVING COMPARTMENT (INsIdE) The first thing to do is to switch on the electrical circuit on the control panel. Check that the water pump is working and purge any air in the circuit, for example by carefully opening the kitchen taps. All air is purged when water starts flowing. Do the same thing for the cold water and hot water circuits which are independent. Air also needs to be purged in the gas circuit. Open the cylinder in the outside compartment, then open the red supply valves to the various appliances. Purge by opening the heater supply valve and switching the gas on. You will know that there is no more air in the circuit when it starts working (flame). Repeat the operation for each device that uses gas. Your preparation operations will be finished when the water and gas are both working. Please refer to chapter XI for operation of each appliance. PLEASE notE: more detailed information from the manufacturer of each of these devices is supplied with the vehicle. 4