Download SIGNAL2000 Tutorial/Reference Manual

Transcript
In some cases the queue value or distance occupied cannot be computed or cannot be displayed
for one of several possible reasons. In these cases, asterisks ‘*****’ are displayed. For example,
for grossly oversaturated conditions, the calculated length of a given queue (in feet) may exceed
the integer arithmetic used which has a maximum of 32,767 feet (over six miles!). Also, in
Models 7 & 8 where the poisson distribution is used, the factorial portion of the formula may
exceed the computational limits of the computer when queues approach one mile in length.
2000 HCM Queue Model
ARRB Queue Model
MBQ Queue Model
SIGNAL97 Queue Model
2000 HCM Queue Model
Models 1 and 4 use the maximum back of queue (MBQ) model defined by the 2000 Highway
Capacity Manual, each using different assumed conditions, as follows. Model 1 is the percentile
queue for the worst lane in a lane group, and Model 4 is the average queue for the worst lane in a
lane group. In both cases, the worst lane is defined by the lane utilization factor used. The
complete documentation for this model can be found in Appendix G of the 2000 Highway
Capacity Manual and the calculations can be observed in the HCM Back of Queue Worksheet
which is produced when the worksheet output is selected. The percentile values used are the
percentile values allowed by the HCM which are closest to those which are requested by the user.
The allowed percentiles are 70%, 85%, 90%, 95% and 98%, meaning that when a given
percentile is calculated, it is expected that that percentage of all of the observed queues will be
the calculated value or less. The distance back from the stop bar is determined using the queued
vehicle length inputs made by the user.
Note that the first publication of the 2000 HCM allowed the computation of an average lane
queue even if an unequal lane utilization factor was used to calculate saturation flow rates. A
published amendment to the 2000 HCM now restricts the computation of a queue to match the
lane utlization factor used for saturation flow rates. Previous versions of SIGNAL2000
calculated these queues as Models 2 and 5, which have since been eliminated.
ARRB Queue Model
Model 3 uses the maximum back of queue (MBQ) model defined by the Australian Road
Research Board, as implemented in the SIDRA5 model. The complete documentation for this
model can be found in the SIDRA5 manual. It is the 95th percentile queue for the worst lane in a
lane group, meaning that it is expected that 95% of all of the observed queues will be the
calculated value or less. The distance back from the stop bar is determined using the queued
vehicle length inputs made by the user.
SIGNAL2000
C-204
Reference