Download 5 DDEC FEATURES - Wanderlodge Gurus

Transcript
DDEC IV APPLICATION AND INSTALLATION MANUAL
5.1
AIR COMPRESSOR CONTROL
Air Compressor Controlis an optional DDEC feature that allows DDEC to regulate engine speed
and load/unload a valve in order to maintain a requested compressor outlet air pressure for air
compressor applications.
The DDEC Air Compressor Control Feature is available with the following software releases:
DDEC III - Release 4.0 (only)
DDEC IV - all software versions (Release 20.0 or later)
5.1.1
OPERATION
The ECM monitors the air outlet pressure while varying the engine speed and operating
load/unload a valve. The valve will be opened or closed. The desired operating pressure may be
varied by the operator, within limits preset by the OEM.
The ECM will activate the Air Compressor Governor Controls when the digital input “Air
Compressor Load Switch” is grounded. Engine speed is governed based on the actual air
compressor outlet pressure versus the desired output pressure. The Air Compressor Pressure
Sensor provides a pressure signal to the ECM.
The engine response to various pressure conditions is listed in Table 5-1.
Result
Pressure Set Point
Current outlet pressure is below the pressure set
point
Pressure in the system continues to increase and
a threshold pressure is exceeded
Current outlet pressure is above the pressure set
point
Engine speed increases as required up to PTO
maximum speed*
The air compressor solenoid digital output is
enabled† (opened)
Engine speed decreases as required down to the
minimum PTO speed.
* The engine will continue to run at PTO maximumuntil the outlet pressure matches the sensor pressure.
† DDEC will open and close the loading valve as a function of pressure with hysteresis. When the pressure
reaches a programmable limit above the pressure set point the DDEC digital output will be grounded.
This output may be used to either open an air compressor vent or close the air inlet. Once the air
pressure has dropped to a lower programmable limit, the digital output will be open circuited which will
either close the vent
Table 5-1
Engine Operation with Air Compressor Controls
Each horsepower rating has an associated pressure range. Horsepower ratings are defined at time
of order entry. The minimum and maximum pressure setting for each of the horsepower curves is
set with the DDDL/DDR, Vehicle Electronic Programming System (VEPS), or DRS. The initial
pressure set point is saved between ignition cycles.
Increase (Resume/Acceleration On)
Momentarily toggling and releasing the Increase Switch (grounding the "Resume/Acceleration
On" digital input) increases set point pressure by 4% of the pressure range. Holding the switch in
the increase position (grounding the digital input), will increase the set point pressure at a rate of
two increments per second. Releasing the switch sets the compressor controls to the higher setting.
All information subject to change without notice. (Rev. (Rev. 3/02))
7SA742 0203 Copyright © 2002 DETROIT DIESEL CORPORATION
5-3