Download onlinecomponents.com

Transcript
INTERBUS Loop 2
Use a screwdriver to break the cable openings out of the connector
hood (1). One opening is required for the remote bus connection or
installation remote bus connection, another opening is required if a
separate supply voltage is to be connected.
•
Push the O-ring (3) onto the threaded joint (4).
•
Place the hexagonal metal nut (2) of the PG-threaded joint in the
recess or in the slot of the connector hood (1).
•
Tighten the cable gland until the end by turning the threaded joint (4)
with a wrench (17 mm [0.669 in.]).
co
m
•
Assembling a Cable and Leading It Through the Connector Hood
s.
7
6 0 m m
(2 .3 6 2 ")
A
5
(0 .2 3 6 ")
on
l
in
ec
8
5
4
om
po
B
1
9
Figure 4-8
4-16
6
ne
6 m m
7
nt
6
5 7 9 6 0 4 0 3
Assembling the components of the connector hood
5796C