Download YLCDRX63N

Transcript
6.11.7 FFC Expansion Connector
The FFC Expansion Connector is the FCI 10051922-2410ELF, a 24-position, 0.5mm, gold plated, bottom signal
latching connector. There are few off-the-shelf FFC cables, so if the FFC Expansion Connector is used to connect
an Embedded GUI Solution Kit to another system, the system designer will likely require a
custom flex cable harness.
The FFC Expansion Connector exposes numerous GPIO signals from the MCU, including the
same seven connections as the 7-pin Power and Communications Connector. If desired,
the FFC Expansion Connector can be the only external connection to the Embedded GUI
Solution Kit.
Since Embedded GUI Solution Kit has the RX63N MCU, the MCU’s Reduced MII (RMII)
Ethernet MAC connection is fully available on this connector for use with an external RMII
PHY, magnetics, and 10/100 Ethernet jack.
The RX63N/RX631 MCUs have extensive I/O multiplexers allowing one of many different
peripheral functions to map to a given I/O pin: consult the RX63N/RX631 hardware
manuals for the complete list of options.
Several signals on this connector are directly connected to signals on other connectors,
including +3V3, RESET#, +5V_EXT. Ensure that common signal connections are appropriate or
you may damage your kit or connected equipment.
6.11.8 JTAG Connector
The Renesas standard 14-pin debug connector allows simple connection to various
debuggers and programmers, including the Renesas E1 and the Segger J-Link RX family
(included in this kit) of debuggers. A full description of the E1 interface can be found in the
E1/E20 Emulator Additional Notes for RX600 Family Application Note.
33