Download User Guide - 3E Plus Insulation Thickness Computer Program

Transcript
Chapter 1 – Introduction
3E Plus® 4.1 Verification
To verify the program has been properly installed the correct version, please follow these directions:
.
1. Start the 3E Plus® computer program by clicking Start >> Programs >> 3E Plusv41.
2. The disclaimer window will appear – clear the check in the “show at start-up box” unless you want to review this every time
the program starts.
3. Left click on “OK”
4. If the “Access Code” window appears, enter the access code (3EPlusv4.1) that was sent in your registration confirmation
e-mail. Without the access code you will be required to wait 10 seconds every time the program is started. Otherwise left
click “Register Later”
5. Once the program is running, click Help >> About
6. You should see the following information box. The important part is Version 4.1
7. Click OK to get back to the Main Page. You are now ready to run 3E Plus® 4.1.
3E Plus® Version 4.1 User’s Guide Aug 2012 Page 1-5