Download User Manual

Transcript
T H E
R E F E R E N C E
D E S I G N
Location of the FPGA JTAG port
The order of the FPGA JTAG chain is FPGA F0->FPGA F1 in order up to FPGA F15. There
are no other components in the chain. Unstuffed devices will not be shown
The voltage of the JTAG chain is fixed at 2.5V and cannot change. Hot-plug on this header is
allowed.
9.1.1 Compatible Configuration Devices
The JTAG header is designed to work with the Xilinx Parallel IV or Platform USB cable. The
JTAG chain is tested using a Platform USB cable at 6 MHz.
The driver installation process for the Platform USB cable is relatively difficult for a USB device.
Follow the instructions carefully.
In order to achieve high-speed configuration using a Parallel IV cable, you need to enable ECP
mode on your parallel port. This is probably a BIOS setting on your computer.
DN9000K10 User Guide
www.dinigroup.com
90