Download About this Manual
Transcript
SECTION 5 Troubleshooting and Maintenance 5-1 Troubleshooting using the LED indicators The four LED indicators on the Option Board provide information on the Option Board mode and status and the network status. When an error occurs, the Option Board indicator pattern provides troubleshooting information. For certain errors, additional information can be obtained from the trip error code given by the four-digit display of the Inverter. In the following sections typical LED indicator and four-digit Inverter display patterns are provided to assist in troubleshooting. To show the status of the indicators, the following conventions are used: OFF ON Flashing Not important (Ignore) Inverter error code Not important (Ignore) Tip 5-1-1 Do not clear the trip before you are finished troubleshooting an error. When you clear the trip, the error code is cleared from the four-digit display. The trip history can however be read back using d080 through d086. This will allow you to diagnose the error even if you accidentally cleared the trip cause. Option board or inverter errors During the Initialization process the RUN indicator will remain OFF. Once the initialization has been completed correctly, the RUN indicator will be ON and the ERR indicator OFF. The table below shows the indicator and display patterns caused by Option Board or Inverter Errors. Table 77 Option board or inverter errors Display & Indicators Possible Cause(s) The Inverter does not power up. The Option Board is not mounted properly. The Option Board connector is damaged. The Inverter RS input is ON. The Option Board encountered a fatal error during Operation. Corrective Action Follow the instruction provided in the MX2-A@ Inverter user's manual section 6-1-4 to troubleshoot. Check that the Option Board is mounted properly and restart the Inverter. Replace the Option Board. Switch the Inverter RS input OFF. Check that the Option Board is mounted properly and restart the Option Board. If the problem persists, replace the Option Board. 43