Download MVME5100 Single Board Computer Programmer`s Reference
Transcript
System Memory Controller (SMC) When the width status bit is set, the block’s ROM/Flash is considered to be 64 bits wide, where each half of the SMC interfaces with 32 bits. In this mode, the following rules are enforced: only aligned, 4-byte writes should be attempted (all other sizes are ignored), and all reads are allowed (multiple accesses to the ROM/Flash device are performed for burst reads). More information about ROM/Flash is found in the following sections in this chapter. In order to place code correctly in the ROM/Flash devices, address mapping information is required. Table 2-3 shows how PPC60x addresses map to the ROM/Flash addresses when ROM/Flash is 16 bits wide. Table 2-4 shows how they map when Flash is 64 bits wide. Table 3-3 PPC60x to ROM/Flash (16 Bit Width) Address Mapping 202 PPC60x A0-A31 ROM/Flash A22-A0 ROM/Flash Device Selected $XX000000 $000000 Upper $XX000001 $000001 Upper $XX000002 $000002 Upper $XX000003 $000003 Upper $XX000004 $000000 Lower $XX000005 $000001 Lower $XX000006 $000002 Lower $XX000007 $000003 Lower $XX000008 $000004 Upper $XX000009 $000005 Upper $XX00000A $000006 Upper $XX00000B $000007 Upper $XX00000C $000004 Lower $XX00000D $000005 Lower $XX00000E $000006 Lower MVME5100 Single Board Computer Programmer’s Reference (6806800H17B)