Download Mania SCX500
Transcript
Rigging the Mania SCX500 The Mania SCX500 must be either: • fastened to a flat surface by means of its adjustable U-bracket, • fastened to a flat surface by means of its adjustable U-bracket and mounting plate, or • attached to a rigging clamp by means of its adjustable U-bracket. Do not install the fixture by any other means, as this can cause the fixture to overheat. Warning! Block access below the work area and work from a stable platform when installing or servicing the fixture. Always use a secure means of secondary attachment that can hold at least 10 times the weight of the fixture. 1. The fixture must be located at least 1 meter (3.3 ft.) away from the surface to be illuminated and at least 0.1 meters (4 in.) from any combustible materials (wood, fabric, paper, etc.). Ensure that the clearance around the fan and air vents is at least 0.1 meters (4 in.). Ensure that there are no flammable materials nearby. 2. If using a rigging clamp (not included), ensure that the clamp is undamaged and can bear at least 10 times the fixture’s weight. Bolt the clamp securely to the fixture’s mounting bracket with a grade 8.8 (minimum) M12 bolt and lock nut through the 13 mm hole in the center of the mounting bracket, or as recommended by the clamp manufacturer. 3. If fastening the fixture directly to a mounting surface, ensure that any fasteners used and the mounting surface can bear at least 10 times the fixture’s weight. The fixture may be fastened using any of the following: • four 6.5mm holes in the sides of the U-bracket • two 8mm holes in the top of the U- bracket • one 13mm hole in the top of the U-bracket. 10 Mania SCX500 user manual